Forge

Forge tool · Oct 8, 2026 · The Forge

The Base Magnetizer

A forge-built tool for getting every magnet in the right way round.

Printed25–50 mmtoolprinted
Riveted Workbench magnetizer on a dark mat, with a red and white die seated in the 40 mm well

Why we built it

Magnetizing bases is one of those jobs every hobbyist puts off. One magnet goes in upside down, and suddenly half your squad repels the movement tray. We wanted a tool that makes it quick and foolproof, and one that looks like it belongs on a Dark Forge bench, not like a plain grey jig.

How it works

The plate does the alignment for you:

  1. Seat a guide magnet in the hole at the bottom of the well. It stays in the tool.
  2. Put a drop of glue in the cavity under your miniature's base and set a magnet into it.
  3. Drop the base into the matching well. The guide magnet pulls the base magnet flush and sets its polarity.
  4. Once the glue sets, lift the base out. The guide stays put, ready for the next one.

Every magnet you do this way faces the same direction, so your whole army behaves on a magnetic tray.

Built for the bases you actually use

  • Five wells: 25, 28.5, 32, 40 and 50 mm, each with a little extra room so bases drop in and lift out easily.
  • Finger notches cut below the well floor so you can get a nail under the base.
  • Push-out holes under every magnet, so a guide magnet can be popped out if you ever need to swap it.
  • Polarity checker: a marked N hole lets you confirm which face of a loose magnet is north before it goes anywhere near the glue.
  • Sized for 5x2 mm N52 magnets. We test-printed a run of hole sizes and locked in the one that grips the magnet snugly. Magnets are not included.

Two styles, one forge

The Riveted Workbench is the Dark Forge edition: a chamfered steel plate with bolted corner brackets, rivets along the edges, and the skull-and-gear Dark Forge Miniatures badge.

Riveted Workbench magnetizer at a three-quarter angle, red corner brackets and the Dark Forge badge

The Anvil Plate is the Sotoverse Forgeworks edition. The whole plate is shaped like a smith's anvil, with the horn, waist and feet, and it carries the Sotoverse Forgeworks badge.

Anvil Plate magnetizer, the Sotoverse Forgeworks edition, with the anvil horn, waist and feet

Printed in two colours

Each plate prints on our Bambu Lab printers with AMS, which switches filament on its own partway up the print, so the badge, size numbers, rivets and brackets come out raised in a second colour. The body is printed without supports.

Tweezers setting a magnet into the Riveted Workbench magnetizer

Get yours